1 / 3
X1C Print Profile - Fiberlogy PP Natural
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This profile isn't perfect, but fine to use as a starting point.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 101
- Wydruki
- 1
- Wyświetlenia
- 296
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution
- Printer: Bambu X1C
- Surface: Engineering Plate (other surfaces might work)
- Hotend: 0.4 mm E3D High Flow ObXidian (the Bambu hotends should work)
- Filament: Fiberlogy PP Natural
- Use at your own risk. I offer no guarantees or support.
Tips
- Use Orca Slicer
- Use Magigoo PP, not just regular Magigoo!!! Seriously, this stuff works (Magigoo PP also works really well for ASA and PC).
- Don't use the AMS, PP is soft and will get crushed a bit by the AMS feeder. It gets crushed again when it goes through the extruder. I've found that jams from retractions are much less frequent when not using the AMS.
- Even though PP isn't very hygroscopic, it can benefit a bit from drying. Don't print from a warm dryer though, it gets way too soft.
- Jams can occur when switching from a high temperature filament like ASA or PC to PP. A cold pull may be needed if a jam occurs.
2024-12-04 Update
- Added Filament and Process .json and .info files from Orca Slicer
- Added pictures of sample print
- Added tip regarding heat creep