1 / 3
X1C Print Profile - Fiberlogy PP Natural
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This profile isn't perfect, but fine to use as a starting point.
- Rating
- 5 / 5
- Likes
- 2
- Downloads
- 101
- Makes
- 1
- Views
- 296
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution
- Printer: Bambu X1C
- Surface: Engineering Plate (other surfaces might work)
- Hotend: 0.4 mm E3D High Flow ObXidian (the Bambu hotends should work)
- Filament: Fiberlogy PP Natural
- Use at your own risk. I offer no guarantees or support.
Tips
- Use Orca Slicer
- Use Magigoo PP, not just regular Magigoo!!! Seriously, this stuff works (Magigoo PP also works really well for ASA and PC).
- Don't use the AMS, PP is soft and will get crushed a bit by the AMS feeder. It gets crushed again when it goes through the extruder. I've found that jams from retractions are much less frequent when not using the AMS.
- Even though PP isn't very hygroscopic, it can benefit a bit from drying. Don't print from a warm dryer though, it gets way too soft.
- Jams can occur when switching from a high temperature filament like ASA or PC to PP. A cold pull may be needed if a jam occurs.
2024-12-04 Update
- Added Filament and Process .json and .info files from Orca Slicer
- Added pictures of sample print
- Added tip regarding heat creep