CR-10 NG - coreXY (beta)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
NG = Next Generation CR-10 is a CoreXY transformation of the basic printer with some high end and fine tuned features.
- Ocena
- 0 / 5
- Polubienia
- 107
- Pobrania
- 296
- Wydruki
- 0
- Wyświetlenia
- 4353
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
NEW VERSION - CR-10(S) NG v1.2 has been released!
THIS IS CURRENTLY INCOMPLETE, CHECK THE CHANGELOG BELOW
CR-10 NG beta - coreXY conversion
This printer is based off of the Ender 3 NG beta v1.1. Supports CR-10 and CR-10S.
PRINTER OVERVIEW
This project is a DIY conversion based on CR-10.
Main goal was to target CR-10 in the same style and spirit as Ender 3 NG.
FEATURES:
Build volume: 305 x 310 x 345 mm.
Printer size (W x L x H): 478 x 582 x 520 mm.
*Compatible with CR-10, CR-10S, .. for now.
FUTURE UPGRADES:
For more information, better orienting in the files and Bill of material, look at the attached documents. Though I highly recommend to use the online versions so you always use the up to date version.
Bill of material, Printed parts: <NOT AVAILABLE YET>
Build manual: <NOT AVAILABLE YET>
Printer overview: <NOT AVAILABLE YET>
STEP assembly: <NOT AVAILABLE YET>
For more information join the RH3D Discord, navigate to Ender 3 NG, then user-mods and then the “CR10NG - Mod for CR-10 V1” post.
Complete changelog:
EDIT 07.06.2025 - Added CNG-BCS step/stl files
EDIT 16.03.2025 - Updated frame parts for electronics panel mounting: CNG-FTL1, CNG-FTL2, CNG-FTR1, CNG-FTR2. Added frame cap for CR-10S: ENG-BRC_509. Electronics enclosure parts added: CNG-EFBA, CNG-EFBB, CNG-EFLA, CNG-EFLB, CNG-EFRA, CNG-EFRB, CNG-EMA, CNG- EMB, CNG-ESA, CNG-ESB, CNG-EPA1, CNG-EPA2, CNG-EPA3, CNG-EPB1, CNG-EPB2, CNG-EPB3, CNG-EPC.
EDIT 03.12.2024 - Added folders, stl and step, for all the frame parts, all bed parts but none of the electronics enclosure, the files are modeled but not verified positionally like DIN rail locations, wire holes, alignment of electrical components etc.
EDIT 03.12.2024 - Copied and edited the sections from the Ender 3 NG printables page from RH3D as well as listing the difference table for printed parts