Attack on Titan - The Cast Portrait Hueforge

Back Story

Attack on Titan is one of my favorite anime. I liked it more when it started. The hiatus took the luster away. It took too long to make and the story took a weird turn. However, it is still one of my FAVES. I have several prints of Attack on Titan.

This one is of the Cast. Looks decent. Colors on point. This is a long print, but if wanted to do it right, should take 3 times as long. That's over a day in an 0.2 nozzle at .04mm. I just don't have the time for that right now. Maybe when I can get another printer. If I print, I will share. Just too much detail to print right in 0.08mm.

Thank you for downloading my works. If you would like to sell my designs, past and future, a commercial license can be obtained from my MakerWorld or Patreon page.

Pictures shown are printed in an 0.4mm Nozzle
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.4
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Blue Gray
At layer #12 (1.04mm) swap to Orange
At layer #17 (1.44mm) swap to Jade White for the rest.

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print. Stringing may occur with Hueforge, just use a lighter to whisk them away.  

More prints: Bookmarks -- Portraits -- Coasters -- Clocks -- Puzzles -- Display Stands -- Display Frames

They are sorted and can be found in my Collections - https://makerworld.com/en/@3djd/collections