1 / 3
Filament Tipper v3 - with square nuts and magnets
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the v3 filament tipper to use square nuts and magnets to place the blades
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 195
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (32)Powiązane
This is a remix of the v3 filament tipper for the MMU. I took the v3 design, added square nuts, and added the magnets back in since I found it hard to place the blades while assembling.
To make this filament tipper, you will need the following:
- 4 x M3x10 machine screws with hex socket heads
- 4 x M3 square nuts
- 2 x 4*2 magnets
- Two 9mm snap-off blades
Printing instructions
Print two of the model, or use the 3FM, which is set up for your convenience. Supports are not needed.
Assembly instructions
- Add a dab of superglue to each magnet hole and add a magnet. Let it dry.
- Push 2 square nuts into the two square holes. Repeat with the other part.
- Snap off two pieces of the blade and add them to each part. You can see how they are supposed to line up.
- Screw the two parts together using the four screws.
Usage
Put the end of the filament into the side with the markings.
Twist it clockwise and counter clockwise until you have a nice tip.