1 / 3
Filament Tipper v3 - with square nuts and magnets — image 1
1 / 3

Filament Tipper v3 - with square nuts and magnets

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remix of the v3 filament tipper to use square nuts and magnets to place the blades

Rating
0 / 5
Likes
7
Downloads
37
Makes
0
Views
195
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — Share Alike

This is a remix of the v3 filament tipper for the MMU. I took the v3 design, added square nuts, and added the magnets back in since I found it hard to place the blades while assembling.

To make this filament tipper, you will need the following:

Printing instructions

Print two of the model, or use the 3FM, which is set up for your convenience. Supports are not needed.

Assembly instructions

  • Add a dab of superglue to each magnet hole and add a magnet. Let it dry.
  • Push 2 square nuts into the two square holes. Repeat with the other part.
  • Snap off two pieces of the blade and add them to each part. You can see how they are supposed to line up.
  • Screw the two parts together using the four screws.

Usage

Put the end of the filament into the side with the markings. 

Twist it clockwise and counter clockwise until you have a nice tip.

 

 

Tags