Pokemon TCG Tin box Insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An insert for the PokemonTCG tins that can hold a 60 card deck. Files for both 3D printing and a vacuum form buck
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 1409
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I recently went through my Pokémon cards to make a deck, and realized that I didn't have a box for them. I could use the many (very nice) 3dprinted deck boxes on this site, but I wanted to use some of my old card tins. I used the measurements of the Dagonite tin, but they should all fit the same. (note that some tins are taller and might need a riser to lift them up… or just print two and stack them!)
Also included is a ‘lid’ of sorts to hold the cards. I have inverted the tin, had it loose in the back of a backpack, etc., and the lid held the cards nicely in the print.
I made the insert the size of a cardboard deck box, so it should fit snug but loose enough to easily get the cards out. No idea if they will fit with sleeves because I simply do not own any sleeves
(EDIT! I recently got some official Pokémon sleeves this weekend from an anime convention, and the default size is JUST a bit too small. there is some space, so you should be able to print the model at 103% - 105% and it should all fit just fine with the sleeves)