Ultimate Traxxas TQi controller GoPro mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount GoPro camera on your Traxxas TQi controller and record all of your RC adventures.
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 102
- Wydruki
- 1
- Wyświetlenia
- 557
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you need to mount a GoPro (or any other camera) on your Traxxas TQi controller get that model and print it out!
The camera mount is at 30° angle to let you navigate your RC model freely.
I've tested it with GoPro 11 and 11 mini - at first, the angle I've used looks a bit weird but after you start riding, it feels fully natural because you don't have to point with the controller at your model.
You gonna need some longer screws, hot glue, or any other glue if you want to make it permanently mounted to your controller.
If you decide to use screws, you need to find a set of two 40x4 mm (the original ones are too short). Additionally, two-sided tape between the mount and controller can stiffen out the whole setup.
Print standing on the longest side, minimal supports are required.
Printer parameters:
- material: PETG, or any other strong and elastic material,
- wall loops / perimeters: 8+
- infill: 40%+ gyroid
- supports: YES, on a build plate only
- screws: two 40x4 mm (max length 45x4 mm - if needed)