Topton N100 Router Skadis Mount (50x50 mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small part to screw into the mounting holes on a Topton N100 router to mount it to a Skadis pegboard
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 336
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Suggested printing in the provided orientation with auto tree supports.
Yes, that orientation. You could print it flat (you'd still needs supports), but then layer lines could cause the pegboard “legs” to break off.
Use M3 SHCS or BHCS to secure to the mount on the router. If you have a SATA SSD mounted inside the case, you'll need to use 4mm screws. Otherwise, 6-8mm screws should work fine and have plenty of clearance inside the case. There's enough clearance on the mount that you don't need to remove the rubber feet.
Suggest pointing the ports up and down so that hot air can rise out of the heat sink more easily. I don't know if that really makes a difference, but it sounds nice.
I printed in ABS scaled to 102% and got a perfect fit. PLA without scaling will probably work fine, but makes me a little nervous because of how hot the device gets.
If there's anything else that has a 50x50mm M3 bolt pattern that you want to mount to a Skadis, this should work fine for that as well.
Hacked this together in OnShape: https://cad.onshape.com/documents/012474a3712a32f59aef4dd8/w/dba1f56b422e547da69e61ab/e/36743cb43e36f5644807cbc9?renderMode=0&uiState=6753c28b5c53bb69e772b8e5