Covid 19 mask breather: Remix, full flat 3D print or laser cut
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
... my Bowden setup struggled with the snap on buttons on the original design. => I redesigned it fully flat with…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 348
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
... my Bowden setup struggled with the snap on buttons on the original design.
=> I redesigned it fully flat with hooks.
Two sizes: for standard 17cm masks as well as 14cm "kid size" masks.
As always: use responsibly at your own risk!
Check on this for additional comfort - at least as long as you are wearing glasses along with your mask:
https://www.thingiverse.com/thing:4599585
Print Settings
Printer Brand:
Anet
Printer:
A8
No
Supports:
No
0.24
Infill:
0%
Filament:
Das filament PETG Blue
Notes:
Geometry designed for following print settings:
Three "shell" outlines with 0.4mm nozzle.
First layer 0.28, second and third layer 0.24
... For minimal print times!
Category: Other