Pokemon Mystery Dungeon Exploration Guild Badge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A badge normally only obtainable in an alternate reality. It brings about waves of nostalgia
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 106
- Wydruki
- 0
- Wyświetlenia
- 469
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Cosplay & Costumes in general
- Licencja
- Creative Commons — Attribution — Share Alike
This wonderful badge was modeled by Speedbuiz, they make wonderful Pokémon Mystery Dungeon related 3d models. Check em out! https://x.com/speedbuiz
As for my work, I engineered two methods of affixing the badge to ones self through either an ID badge holder or by using a broach pin. The parts used are as follows.
Broach pin version
BeadNova Bar Back pin
To attach the broach pin, add some super glue to the bottom of the pin and stick it to the back of the badge. Then, apply a small amount of super glue to the top of the flat part of the pin, then attach the backing plate to the pin and badge.
Clip version
Slide the snap into the bottom hole of the badge and close it.
For printing, to get the best finish on the backside of the badge, you will need to use support material.
No Mount version
This version of the badge is just the badge itself. it does not have any means of attaching it to clothing or bags whatsoever. This version is for if you just want the badge itself, or want to make your own attachment method.
The badges you see on this post were made on a Prusa XL 5 head printer with 4 colors of PLA for extruders 1-4, and PETG support material with interface set to snug and 0 contact distance. Layer height is set to 0.2 for layers 0-4.4mm and .1 for 4.4mm to 16mm, for better top surface finish.