Cable Twisting Tool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a tool that will help you make nice twisted wires.
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 72
- Wydruki
- 0
- Wyświetlenia
- 460
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
! Made for wires with an external diameter of 2mm. Can be scaled up in slicer. (200%=> 4mm)
Quite simple. Put is wires, twist it and get a nice cable.
One wire must be in the centre, then the others in the outside holes.
After the wires are in and clamped in a vise, twist clockwise and the wires will twist together and, if the coating is not sticky, should advance by itself.
In the end, do a couple of passes with a heat gun to induce memory in the resulted cable, secure the ends to prevent fraying and done!
I recommend to print this in PETG due to its lower friction, but PLA will also work. No supports required.