Cable Twisting Tool
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a tool that will help you make nice twisted wires.
- Rating
- 5 / 5
- Likes
- 14
- Downloads
- 72
- Makes
- 0
- Views
- 460
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
! Made for wires with an external diameter of 2mm. Can be scaled up in slicer. (200%=> 4mm)
Quite simple. Put is wires, twist it and get a nice cable.
One wire must be in the centre, then the others in the outside holes.
After the wires are in and clamped in a vise, twist clockwise and the wires will twist together and, if the coating is not sticky, should advance by itself.
In the end, do a couple of passes with a heat gun to induce memory in the resulted cable, secure the ends to prevent fraying and done!
I recommend to print this in PETG due to its lower friction, but PLA will also work. No supports required.