1 / 22
Llama' s Improved Filament Dry Box - Economy grade with bearings and Bowdens — zdjęcie 1
1 / 22

Llama' s Improved Filament Dry Box - Economy grade with bearings and Bowdens

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Improved DIY dry box design. Includes: PC4-M10 porting, 3d printed bearing compatible spool carrier & core.

Ocena
0 / 5
Polubienia
17
Pobrania
94
Wydruki
0
Wyświetlenia
827
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I didn't like the options out there with the spool carriers that spools fall of nor do many have clean ports for Bowden tubes, nor do they work with 3d printed bearings. Most are limited to the size ranges they are compatible with, or are a pain to load…

These parts work with what I found reasonable and replaces the rest with my own work as inspired by others.

Compatible with:

  • 52-60mm spool core diameters (Interior Diameter)
  • Spools up to 102mm Roll Diameter (Outer Diameter)
  • Spools up to 76mm width
  • PC4-M10 Bowden port

New components Include:

  • Spool Core
  • Spool Hanger (top or bottom mounted)
  • Bowden Keeper (Sealing Bowden / Filament catcher)
  • PC4-M10 Bowden port cone
    • features: 
      • conical entry feed (smoother feeding from full to empty)
      • interior Bowden sealing surfaces (smoother feeding of material through Cone to PC4-M10 to Bowden)

You'll need the Following:

Additional Materials (I bought from Amazon - not affiliated with any of them):

(AWSOME WORK BY THE DESIGNERS BTW)

3D printable Bearings !!!!: 
Dry box Desiccant holders:

 

Credit for some of the core design Ideas goes to: 

  1. Credit for the idea to hold the spool by a ring started here: https://www.printables.com/model/835472-4l-cereal-filament-dry-box
    I redesigned the ring entirely to fit my boxes, and hole the spool where I wanted it. As well as mounting to the LID with Hot Glue. This drastically improved the experience of mounting the spools.
  2. Same designer had a spool holder I liked but it used the OD to seat the bearing. I didn't like that so I redesigned a spiral that used the OD of the Bearings to spool and the ID to the holder.  (This allows for a much easier and consistent installation)
  3. Credit for the Porting goes to:
    1. https://www.printables.com/model/7978-prusa-mk3smk3s-reverse-bowden-filament-sensor-cove
    2. https://www.printables.com/model/197503-knurled-pc4-m10-filament-pass-through-with-funnel
  4. Inspiration for the “Bowden Keeper”
    1. https://www.printables.com/model/827355-4mm-filament-tube-end-cap-for-reverse-bowden

Tagi