Cooler Master Atmos with memory fan mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enables mounting two 40mm fans above memory in small form factor cases like the dan a4-h2o when used with an Atmos AIO.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 621
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
The memory in my sff case (Dan A4 H20) was getting quite toasty, maxing out at nearly 65 degrees celsius while stress testing at 1.4V. Unfortunately there isn't really a fan mount solution anywhere, other than just glueing them to the side of the PSU mount, or friction fitting them somewhere.
So this is why this exists. With the two 40mm fans, the memory now maxes out at roughly 50° celsius with a max fan speed of 75%.
I would recommend to set the fan curve depending on the VRM or Motherboard, to only speed them up when there is actual persistent load on the cpu for a longer period of time.
I would also recommend to print it at 0.15mm or lower, because of the little friction knobs to the side of the model, which are required so it fits nicely into the socket. I would also recommend PETG or something else that is reasonably temperature resistant.
Your memory will need to be quite low profile, so anything much larger than corsair vengeance or team group expert will probably be too large. ~46mm memory module height should be the approx maximum since there is about 14mm space left from the team group sticks to the fans.
Other Parts shown in the picture:
ML Atmos 240 AIO
2xNoctua NF-A4x10 PWM (but any other 40mm x 10mm fan should theoretically work)
Strix B650E-I
Team Group DIMM 48 GB DDR5-6400 (CTCED548G6400HC32ADC01)