Hermit Crab Mount and Hermit Crab Apogee Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hermit Crab mount for CR-6 or any printer with a linear rail on top of the X gantry + Apogee Mount for the hermit crab
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 175
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
In my quest to finally stop upgrading the toolhead on my CR-6, I decided to install a Hermit Crab v2, that way if I have a problem I can just pop the toolhead off instead of disassembling everything in the enclosure or pulling the printer out.
This is a remix of the Apogee toolhead for the CHC Volcano. This will take any j-head hotend of appropriate length.
You do have to mount the extruder with the motor facing forward because there isn't enough clearance for the standard mount.
I printed all these parts flat side down in SirayaTech ASA-GF. As this setup pushes the CG pretty far forward, I recommend using a very stiff filament like this for the hermitcrab mount and apogeeredux_mount (other good options would be PC-CF, ABS-GF)