Hermit Crab Mount and Hermit Crab Apogee Remix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hermit Crab mount for CR-6 or any printer with a linear rail on top of the X gantry + Apogee Mount for the hermit crab
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 10
- Makes
- 0
- Views
- 175
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution
In my quest to finally stop upgrading the toolhead on my CR-6, I decided to install a Hermit Crab v2, that way if I have a problem I can just pop the toolhead off instead of disassembling everything in the enclosure or pulling the printer out.
This is a remix of the Apogee toolhead for the CHC Volcano. This will take any j-head hotend of appropriate length.
You do have to mount the extruder with the motor facing forward because there isn't enough clearance for the standard mount.
I printed all these parts flat side down in SirayaTech ASA-GF. As this setup pushes the CG pretty far forward, I recommend using a very stiff filament like this for the hermitcrab mount and apogeeredux_mount (other good options would be PC-CF, ABS-GF)
