Lenovo Tab M10 HD Plus (x606f and X606x)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a tablet case for the 10.3inch Lenovo Tab M10 HD Plus (x606f and X606x)
- Ocena
- 4 / 5
- Polubienia
- 6
- Pobrania
- 135
- Wydruki
- 0
- Wyświetlenia
- 613
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an easy print. Less than 4 hours total on a Neptune 4. It fits snug and will not fall off. I printed this in PLA, but PETG works too. 95A TPU will not work. It is too flimsy and does not get a grip. I printed the big one with 12 walls and 60% Gyroid infill. The small one was 8 walls and 60% Gyroid. The dovetail joint is a little tight, and that is by design. Its hard to get in place, but once its there, it's set. Mine printed and was a little small, so scale 1% if your printers tolerances aren't perfect. I filled in the crack with a 3D pen, so its like it printed perfectly.