multiboard sprayer hanger/holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
this is a multiboard hanging sprayer head mount A.K.A. a sprayer hanger
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 55
- Wydruki
- 1
- Wyświetlenia
- 215
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Public Domain
settings: i am yousing PLA+, no supports needed, 1 skirt loop, for the most strength with a hint of flex to snap on tight i recommend 6 wall loops and if you want infill that's up to you but not needed Time according to normal speed on ankermake M5C 29min, it is a bit stiff to snap in and is very snug to pull it out of the multiboard pull up on it like its a soda tab opening it up, otherwise you need a lot of strength to pull it off.
options: you can make a 3-4 wall loop with 25% or more on 3D honeycomb infill to make it just as good time is 28 min with a bit more flex.
WARNING!!! Do NOT make completely solid it will not snap in.
NOTE: As far as i know this is the final make/model of it, if i make any changes to it ill put it in the notes here Thanks!