1 / 5
Seat rail Fischer-style rear bike light mount — zdjęcie 1
1 / 5

Seat rail Fischer-style rear bike light mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount for those Fischer-style rear bike lights that have a square base. Mounts to the angled part of the seat rails.

Ocena
5 / 5
Polubienia
8
Pobrania
87
Wydruki
1
Wyświetlenia
542
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I needed a way to mount my new bike light but my seatpost is taken by a bag I attached to carry tools and some essentials that I want to leave on the bike at all time. So I instead designed a seat rails mount.

Should work with any light that uses the 16.50x16.50mm square “slide in” mount. There are a few of them on amazon. I have the “KIT-R1” but the mount itself was designed around one from Fischer, which shows a lot of these lights share the same mounting system.

The seat I designed around is a WTB Volt. I don't know if it uses a standard seat rails spacing and the dimensions I ended up with are a pretty exact fit. I hope it's still useful for other people.

Two main goals were followed:

  • No supports
  • As small as possible

For the no supports, you can check the other remix as it's more focused on that aspect of the redesign.

As for the “as small as possible”, I think it allows enough clearance to mount most under-seat bags. Mine has a few mm free and it's basically as large as I can fit under the seat.

You'll need two 4mm wide zip-ties to mount it to the seat. The grooves are 5x2mm so anything smaller than that should also work. You can try placing the zip-tie's “head” on either side of the part, I've found that the attachment is more secure when the “head” is on the light's side.

The only mandatory print setting is 0.20mm layer height so the bridging works. Otherwise I recommend at least 4 walls for strength and to make the flexture latch more resilient. Also you should use a tough filament that will survive the harsh outdoors like PETG or ABS. I used eSun ABS+ (a blend of ABS and PETG) and it seems to do the job. PLA is not really suitable for this.

Tagi