Fairphone 5 camera bump smoother
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fix for the Fairphone 5 camera bump (1.9mm) to prevent getting stuck or wobble on a flat surface
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 143
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Share Alike
There is two version:
- The normal one to glue directly to the back of the phone with glue
- The multipart one, where there is a 0.2mm “channel” to place double sided tape
Printing:
I recommend printing in PETG if you want a polished result because it’s way easier to sand
For the multipart variant use 2 incompatible materials like PLA and PETG so they can be separated after print
Process of the final version in photo:
I used the multipart version with the channel in PLA and main body in PETG
Used a Prusa Mini at at 0.1mm layer height, in order to improve finish, I pushed the flow ratio to 108% in order to reduce visible void after sanding.
For sanding, used 180 grit down to 1000 grit wet sanding, then finished with a varnish “buffed” with a tissue to leave only a very thin layer.
For fixing I used 2mm wide 3M tape in order to be able to remove it if needed