1 / 2

Clamp for LED Strip-Controller by Huemihui

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a complementary file for the controller for Huemihui LED strips

Aktualizacja u źródła: 15 gru 2024

Informacje o modelu

This is a complementary model to the LED Strip Holder for the LED controller of Huemihui LED Strips.

M3x4 screws (e.g. M3x4 out of your Prusa Enclosure Kit)
2 regular M3 Hex Nuts (e.g. M3n out of your Prusa Enclosure Kit)
Controller of the LED Strip set (roughly 10€, Affiliate Link) https://amzn.to/3ViVG1k
Foam Adhesive Tape from the LED Strip Set

Print the Part (I used Prusament PETG with 0.15mm structural setting and 15% infill in the Prusa Slicer). Use an orientation of the part on the build plate such that it prints diagonally up (look at attached m3f file for reference) and use lots of support from buildplate (i recommend organic support). This ensures the Layer Lines are not in line with the snap mount which will increase the part strength
insert the hex nut in the matching recess
bolt the part on the outer side of your prusa enclosure with an M3x4 screw
peel one side of the protective cover of the foam adhesive tape and attach it to the bottom side of the LED controller
remove the other side's protective cover of the foam adhesive tape
snap the led controller into the bracket (can also be slided in, but make sure not to touch the back wall with the adhesive tape)
gently push the controller with the attached adhesive tape to the printed part
Enjoy all the brackety brackiedness of your controller mounted to your printer
if you want to support me you can do so on ko-fi https://ko-fi.com/dickenhobelix