Christmas tree with space for a bauble

My goal was to create a large illuminated Christmas tree with a bauble cutout that could be printed on printers with small 18x18cm work tables. Christmas tree is divided into three parts. The total height of the Christmas tree is 30.5 cm.

What you need:

1.  LED strip (about 60cm x 10mm). Preferably RGB. It's good if the tape can be shortened frequently. The tape cannot be waterproof. I recommend USB powered - https://pl.aliexpress.com/item/1005003610905650.html
2. Plastic glue,
3.  Filament PLA & transparent PETG, 

Part printing:

• The main parts of the Christmas tree can be printed from PLA or PETG.
• Semicircle - LED strip holder must be printed from PETG. You need a material that is flexible and resistant to temperature.
• Semicircle - LED cover must be printed in transparent PETG.
• The stars must be printed in transparent material.
• Attention. Print all stars. The stars have different sizes. The lower ones are slightly smaller than the upper stars.

It is best to print elements flat. With supports.

Assembly instructions:

• It is best to glue the three parts of the Christmas tree with plastic glue.
• Put the stars in their places. Remember that the 4 stars on the Christmas tree have different dimensions.
• Stick the LED strip onto the LED holder. Start from the bottom, outer side. Ride the tape to the end and come back on the other side. Remember that the LED should also illuminate the last star. There is some space at the end for excess LED strip and cable.

• Insert the strip holder with the glued LED strip. Route the power cord outside. There is a hook at the top of the Christmas tree. And in the middle there is a blockade.

• Install the LED strip cover. There are small grooves at the bottom and top of the Christmas tree.
• Place the Christmas tree in the stand. The stand is loose. If this bothers you, you can stick it to the Christmas tree. Now find the bauble and place it in the Christmas tree.

I think a 10 cm bauble fits best. Have fun!