GPIO Hackerboard Magnetic Housing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic Housing for the Prusa GPIO Hackerboard
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 73
- Wydruki
- 3
- Wyświetlenia
- 679
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is magnetic housing for the Prusa GPIO Hackerboard Set.
It's modeled so the Hackerboard snaps in using the four holes at the corners. There is a hole modeled through the bottom so you can push the Hackerboard out to remove it.
I also added a recess in the model for any soldered connections if you decide to add a pin header strip to your board.
Remember to add a pause at the last layer before the magnet holes are covered so you can add the two magnets to the baseplate.
Here's a link to the magnets I used
Included an .step file. I modeled this in Rhino3D, so the .step file is an export. Please let me know if it doesn't work properly.