Secretlab Mitutoyo Caliper Holder Magnetic 150MM
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use this to for a neat way to store the calipers on your desk. MAKE SURE TO PAUSE ON THE CORRECT LAYER, READ BELOW :)
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 14
- Wydruki
- 1
- Wyświetlenia
- 360
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
I have been trying to free up as much space as possible on my Secretlab desk. Figured this would free up even more space and give it a neat little place to store them.
I used this on my Secretlab Magnus Pro desk, but I would imagine it would work with anything metal as long as it is ferrous.
This model does require magnets to be inserted mid print. So make sure you pause at the correct layer in the printer. You want to pause exactly before the top layer goes across the pockets, insert the magnets, and then resume printing.
WARNING! Be careful if your probe for your Z offset is magnetic! I have a metal tip on my S1 Pro and the magnets will pull it down after inserting them. I had to put tape across the bottom of the tip to make sure the magnets didn't pull it down and drag across the pockets.
These are the magnets I used: https://a.co/d/bmE0Ddn