BGS (Beckett) HoneyComb Wall Card Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
HoneyComb Wall Plug to fit a Beckett graded card
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 273
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
I use the PSA / Beckett card stands a lot for my display cards in my office, but I am in the process of printing a honeycomb wall for my office and as this is a playing card rather than a TCG card it doesn't quite fit with the rest of my display, so I decided to add the honeycomb adapter to the back of sellingson's original model and created a 45 degree angle around the base to make it look less “sharp” as its not to sit flat but float affixed on the wall instead.
It is specific to my use case but uploading in case anyone else would like it.
My print:
Prusa Mk3s REVO
ESUN PLA+ VERY PERI
0.4 nozzle, 0.2 layer height, 220 first layer 215 rest of print, 60 bed, 20% infill.
start 160 as bed mesh climb to 220, pause at purge/wipe for few seconds (my preferred starting g-code to ensure the nozzle is clean for the first print and a decent mesh bed levelling)