BGS (Beckett) HoneyComb Wall Card Stand
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.59 – €1.94 net (excluding VAT)
For file: BGS_Card_Stand_HoneyCombWall_0.2mm_PLA_MK3S_1h58m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.76 excluding VAT (range midpoint).
- Weight reported by the author
- 18 g
- Print time reported by the author
- 1.96 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
HoneyComb Wall Plug to fit a Beckett graded card
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 39
- Makes
- 0
- Views
- 274
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
I use the PSA / Beckett card stands a lot for my display cards in my office, but I am in the process of printing a honeycomb wall for my office and as this is a playing card rather than a TCG card it doesn't quite fit with the rest of my display, so I decided to add the honeycomb adapter to the back of sellingson's original model and created a 45 degree angle around the base to make it look less “sharp” as its not to sit flat but float affixed on the wall instead.
It is specific to my use case but uploading in case anyone else would like it.
My print:
Prusa Mk3s REVO
ESUN PLA+ VERY PERI
0.4 nozzle, 0.2 layer height, 220 first layer 215 rest of print, 60 bed, 20% infill.
start 160 as bed mesh climb to 220, pause at purge/wipe for few seconds (my preferred starting g-code to ensure the nozzle is clean for the first print and a decent mesh bed levelling)