Echo SRM-225 Straight Shaft Trimmer Wall Bracket / Mount / Hanger with Lanyard Loop
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount that trimmer on a wall, help keep the garage organized.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 104
- Wydruki
- 2
- Wyświetlenia
- 670
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
A three-piece bracket, one mounts on wall, the other two bolt together around the 25mm/1” shaft. The shaft part has a lanyard loop that can be used with a shoulder harness.
Max print size of largest object is 70x125mm on the x/y axis and 156mm on the z. I used PLA but PETG or something stronger might be better filament. Your print needs to be strong on this, so use 25% infill (I prefer Gyroid) with 3 or 4 perimeters. Layers height does not matter, I used 0.32mm.
The wall mount part is designed for imperial #8 or #10 (preferred) screws. Make sure it is well secured to the wall so it does not pull-out under the weight of the trimmer.
The shaft parts require two ¼-20 x ¾” (or longer) bolts with nuts. There are nut pockets to assist when you mount the shaft parts.
The shaft bracket must be mounted below the hand grip/throttle control. DO NOT ATTEMPT TO MOUNT IT JUST BELOW THE ENGINE. When mounted, the hook of the shaft bracket must point towards the engine and the lanyard loop should be away from the engine. When placed in the wall bracket, that hook catches an internal crossbar that helps prevent the trimmer from sliding out of the wall bracket. The geometry of that hook means that when placing the trimmer into the wall bracket, the trimmer must go in with a slight tilt of the engine towards the wall. The same holds true when removing the trimmer, push the engine towards the wall, then slide the trimmer out.