DIL-IC Test Clips
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Test probes for DIL ICs to trace logic signals with a meter or a logic analyzer.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 279
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Normal single pin test probes are difficult to fix at DIL Ics which are soldered in. These 14 to 40 pin probe are mounted on an IC and give excellent access to measuring with an oscilloscope or a logic analyzer.
As visible on the pictures, you need two clip halves, a holding frame and optionally a spring (0.5*7*12mm, and 0.5*7*19mm for the wide clips). The wire to be inserted was from an electrical cable (NYMJ-3*1.5); this is stiff enough for the purpose.
Printing: you should place the clips vertically.
PLA 0.2mm, 100% infill
Printed with Prusa MK3
Depending on the quality of the print the half cylinder of the clip (holding the spring) might need removal of overhang with a sharp knife, see picture.