Soshine Solar Panel Mount (30deg variant)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the very good model by @pdxlocs for a common 6W soshine panel. It has been changed from 45 to 30deg
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 336
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remix of the very good model by @pdxlocs for a common 6W soshine panel. It has been changed from 45 to 30deg and holes have only been maintained on the panel side – I prefer glue up or other bonding on the bracketry side to minimize water ingress due to drilling into my electronics enclosures.
I reduced the angle to gain some south-facing efficiency and have better snow shedding in the winter.
You'll need to print one and a mirror image. I've included two STLs if that's easier, but you can easily copy and mirror an object in your slicer as well.
Note that this will require either printing on its end or using supports due to the 60degree side.