Cable Clip for extrusion (ASR)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cable Clip for 15 series (imperial) extrusion
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 97
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Cable clip that i design for my ASR4 sim rig from Advanced Simracing, it will fit other 1st gen Advanced Simracing rig or monitor stand.
Advanced Simracing is North American therefore they use imperial 15 series extrusion (1.5in) This will not work with 40 series metric simracing rig but there might be a workaround with scaling percentage to make it fit your rig, I invite people who test it to put percentage scaling in the ‘’make'' section of my model
I recommend 0.2 layer height and 5 perimeter layer to make the model 100% filled. You can easily fit 20 of those clip on your prusa bed (see picture)
You can also use this model for any other project with 15 series (imperial) extrusion if you want clean cable management