Base for TinyTapeout 06+ Demoboard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple base, that screws on and protects the bottom of the PCB
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 47
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a base or skeleton case, that protects the underside of the PCB, mostly from unintended shorts do to accidentally placing the board on top of conductive elements on your workbench.
There is space inside for all the through hole connectors (also the ones that are not populated initially), and the stock rubber feet will also fit, so you don't have to modify the board in anyway.
It does get raised up a little higher from the table, so you might need similar support under attached PMODs with large connectors or other things connected, to not put stress on the headers.
The base comes in two variants:
- One that is designed for M2 brass inserts
- One for using M3 screws directly into the printed hole.
Except for the hole size, the two are identical.
OpenSCAD design is included, if you want to tweak or modify and built on the design.
I also added small rubber feet on the bottom, so that it more or less stays put when testing and moving attached wires.