Car Ramps Kit Card and single parts - 1:24 scale garage diorama accessories
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Print this must-have accessory for your diorama workshop or garage! No supports needed - fully scalable.
- Ocena
- 0 / 5
- Polubienia
- 98
- Pobrania
- 549
- Wydruki
- 1
- Wyświetlenia
- 1390
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Summary
This is a easy-to-print 1:24 scale model of car ramps in a kit card style. The single parts are also available.
Print
Print with 0.2 - 0.3mm layer height.
No supports are needed.
Use 3 perimeters - infill not needed.
Small print bed? Place it at an 45° angle on the print bed!
Dimensions at 100% scale (1:24)
Height: 22mm
Length: 71mm (short) & 200mm (long)
Width: 20mm
Scaling is possible completely and without any limitations.
Calculation formula using the example of target scale 1:18:
24 / [18] * 100 = 133% scale in your slicer
Other models
I will also try to publish other car related garage / diorama models. Stay tuned!
I hope you had as much fun printing and assembling it as I did :-)
Do you like my work? I would be very happy if you would support my work on Ko-fi.