Voron 0.2 (V0.2) Cable Management Raceways
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Compact DIN rail cable managment rails for Voron 0.2 (V0.2)
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 60
- Wydruki
- 0
- Wyświetlenia
- 971
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Shorter cable raceways (70x12, 90x12, 90x20) are screwable to DIN cleats with self tapping screws (2.0x10 or similar). Longer 130x20 rail was screwed directly on rear panel
Mounting of rPi and SKR Pico was done with DIN cleats (by VORON Desing). Cables running to/from MCU and rPi are held nicely organized in cable raceways (modifed model). PTFE tube is attached to DIN rail with clamp originaly maent for clamping of cable.
Installation
Longer piece of DIN rail 35x7.5x~200 mm was secured in the middle of rear plate with combination of longer BHC M3 screws and bigger washers (3.2 mm, DIN 9021).
Cable raceways was screwed to DIN cleats with self tapping screws (1.9x10 mm) and can be clipped to DIN rail. Before that, longer cable raceway (130x20) was screwed to rear pannel, under DIN rail, with BHC screws. Cover for 130x20 was split in two parts for easier installation.
In the cover picture 90x12 rail is used in middle, but 90x20 will provide more space, left one can be ommited.
Mounting location for 35x7.5mm DIN rail and 130x20 cable raceway:
(Cable clamp was used for zip-tying PTFE tube and attaching to DIN rail - https://www.printables.com/model/133493-din-rail-cable-clamp)
Everything was printed from black ABS