Kitchen cabinet mounting jig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
an easy to use mounting jig to help set up all doors to same hight
- Ocena
- 5 / 5
- Polubienia
- 36
- Pobrania
- 171
- Wydruki
- 0
- Wyświetlenia
- 1572
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Because my profession require me to keep mounting kitchen cabinet doors and most of the time I am alone at work I was looking for something what could help me to always fit the doors neat and same level. I come across device which you can buy but it cost £50+ so I decided to reproduce it and print from PETG.
EDIT 08.01.2025
step by step instructions how to assembly and use
- Print it out ;) .
- Using threader make thread in middle hole of the slider.
- Using threader make thread in top single hole (do not do thread on any of the triple hole on top).
- Bolt 80mm goes to threaded hole on top, before fitting attach knob with glue.
- Fit pressing feet on bottom of 80mm screw and secure with self locking nut.
- Slide 2 6mm bars in to the smaller holes on top
- Fit sliding block on rails
- Push bars until its pressed to the bottom and secured in designated holes on the base.
- Fit 125mm bolt through large hole at top, sliding block and bottom base.
- Secure 125mm bolt with self locking nut
To successfully Achieve mine goal I purchased
2x 6mm diameter 95 mm long steel roods for slider
1x 125mm M10 screw
1x 80mm M10 screw
2x M10 self locking nuts
Printing settings I have used:
Print bed 75C all time
Nozzle 255 first layer 235 rest
ELEGO RAPID PETG 17mm3 / s
chamber temp 70C
no Brim
Print takes about 2hrs to complete