1 / 2
Bosch 36V Ebike Battery connector with CAN pins (5 pins) 100W — zdjęcie 1
1 / 2

Bosch 36V Ebike Battery connector with CAN pins (5 pins) 100W

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I wanted to be able to use my Bosch Powerpack 500 battery as a powerbank.

Ocena
0 / 5
Polubienia
3
Pobrania
97
Wydruki
0
Wyświetlenia
735
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

Use an Arduino with MCP2515 to Power on the Ebike battery (MCP2515 lib needed)

Used the components as described in

https://www.printables.com/model/49417-bosch-36v-ebike-battery-connector-diy-2a-charger

Isolate with heat shrink and hot melt glue. Use a multimeter to assure all isolation is good.

Tested with 100W load.

The connector is not tested at maximum power (not equivalent to original) 

The cable gland can be used with two separate cables two wire for CAN three wire for power output and 5VDC to enable charging.

BE CAREFUL: short circuiting the Ebike battery or other misuse is VERY dangerous and can result in fire, explosion and heavy injury!