Foil guard socket improvement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Improvement of a foil guard socket such that an extra 8mm wrench is not needed to fasten the socket.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 38
- Wydruki
- 1
- Wyświetlenia
- 163
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
A typical foil socket requires both an 8mm wrench and a screwdriver to fasten the sockets. The wrench is needed to keep the hexnut in place while you use the screwdriver to fasten the socket (see picture of an unmodified socket).
I find this a bit inconvenient, and a major cause of field problems because people don't fasten the socket well enough and the foil wire gets loose.
I printed a plastic part that keeps the hexnuts in place and makes sure the wire is well insulated from the foil internals.
I did it in plain PLA, no support needed.