FLSUN V400 PTFE tube curve guide Filament holder at base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keep your spools at the base and easily feed through the top and filament sensor with this PTFE tube guide.
- Ocena
- 4 / 5
- Polubienia
- 9
- Pobrania
- 48
- Wydruki
- 1
- Wyświetlenia
- 327
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
Why me make:
My printer is on a high table with the spool holder nearly touching the ceiling. This makes it quite difficult to change. Therefore, I designed this, a basic guide for the PTFE tube to be curved around without any sharp points causing stuckness. I slopped this together in a few minutes, but it looks pretty decent and works as expected.
Amazon.com Shopping:
- FLSUN V400
- FILAMENT PLA, PETG… not tpu
- 1.75mm PTFE Tube 30cm length or a slightly larger diameter one for a less friction fit. I used what I had.
- Double side sticky tape I used some gorilla stuff, I designed base to be same width. THIS IS SOOOO AWESOME! CHECK IT OUT HERE
Print settings:
idk, whatever basically.
Supports: NO. (your printer will probably break)
Walls: 2+ ( the more the better as always)
Infill: Doesn't matter
Make sure that the overhang layer time is slow enough and fan is on pretty good so the overhangs turn out good. Printed mine out of super old PLA that's been sitting out. Turned out ok except for a load of stringing.
Approximately <50 grams or less
How human must install:
- Print it with current spool holder system (duh)
- Remove from build plate (obviously)
- Remove screws from top (do not screw up on this very crucial step)
- Remove top cover
- Remove existing PTFE tube
- Install longer tube
- Replace top cover guiding tube through hole
- Replace screws (i lost them all :(
- Go search and find the part you just printed
- Put sticky tape on bottom
- Carefully insert the PTFE tube into the hole in the guide
- Slowly push in and keep finger guiding on upper areas
- Keep pushing, after comes out other end, pull until guide gets close to machine
- Remove thingy from sticky tape
- Stick the mount firmly onto top of machine
CONGRATULATIONS! You have now installed the bowden guide.
You no longer have to precariously climb onto a ladder to change filament.
Stay busy, have fun, don't dii, and print more stuff.
i dare you go print a 100% solid infill cylinder 300mm diameter and 375mm tall
