Cordless drill and screwdriver mount, my new Ryobi fits to
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Revamp with larger and an extra hole all 4mm, plus a thicker based version
- Ocena
- 5 / 5
- Polubienia
- 31
- Pobrania
- 142
- Wydruki
- 7
- Wyświetlenia
- 718
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
On reading the comments from the original it appeared the screw holes were being reported as to small. https://www.prusaprinters.org/prints/55082-universal-cordless-drill-hanger So before printing I added an extra screw hole and increased the original 2 holes to 4mm
This was very sturdy when mounted. However as I was mounting a slightly larger cordless drill, the picture shows a piece of ply mounted behind to make a better fit.
Therefore there are 4 prints. 2 copies of the original but with the extra and larger screw holes, Left or right facing. The other 2 are copies of this but 3.5mm thicker base rather than getting the plywood out as I had 2 to mount.