Cordless drill and screwdriver mount, my new Ryobi fits to
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Revamp with larger and an extra hole all 4mm, plus a thicker based version
- Rating
- 5 / 5
- Likes
- 31
- Downloads
- 142
- Makes
- 7
- Views
- 718
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
On reading the comments from the original it appeared the screw holes were being reported as to small. https://www.prusaprinters.org/prints/55082-universal-cordless-drill-hanger So before printing I added an extra screw hole and increased the original 2 holes to 4mm
This was very sturdy when mounted. However as I was mounting a slightly larger cordless drill, the picture shows a piece of ply mounted behind to make a better fit.
Therefore there are 4 prints. 2 copies of the original but with the extra and larger screw holes, Left or right facing. The other 2 are copies of this but 3.5mm thicker base rather than getting the plywood out as I had 2 to mount.