1 / 3
FortiExtender 511F Gang Plate Mount with Cable Slot — zdjęcie 1
1 / 3

FortiExtender 511F Gang Plate Mount with Cable Slot

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Ceiling mount option for the FortiExtender 511F that's way easier than the one included in the box

Ocena
0 / 5
Polubienia
0
Pobrania
9
Wydruki
0
Wyświetlenia
78
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

If you're finding yourself here voluntarily, then I apologize in advance.

I was attempting to retrofit an existing AP installation that had PoE to connect a FortiExtender for support purposes, since it was in a wide-open area with no interference.  However, I discovered upon unmounting the old hardware that the whole thing was installed over a single gang box with a network cable draped through.

After some trial and error, this is the best approach I could come up with that looked the best while remaining easy to install and support. In case you're wondering why one side is slightly longer than the other, it's because I misread the original measurements and decided to YOLO it and make it a little longer on one side. It covers the entire gang plate so you can't even tell, let alone the fact there's a cable hanging down with it. The holes in the band are where you can use a screwdriver/drill to put the screws in the box.

I recommend printing this at an angle to reduce the amount of support material needed. I included a photo for reference.

Tagi