1 / 3
FortiExtender 511F Gang Plate Mount with Cable Slot — image 1
1 / 3

FortiExtender 511F Gang Plate Mount with Cable Slot

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Ceiling mount option for the FortiExtender 511F that's way easier than the one included in the box

Rating
0 / 5
Likes
0
Downloads
9
Makes
0
Views
78
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial

If you're finding yourself here voluntarily, then I apologize in advance.

I was attempting to retrofit an existing AP installation that had PoE to connect a FortiExtender for support purposes, since it was in a wide-open area with no interference.  However, I discovered upon unmounting the old hardware that the whole thing was installed over a single gang box with a network cable draped through.

After some trial and error, this is the best approach I could come up with that looked the best while remaining easy to install and support. In case you're wondering why one side is slightly longer than the other, it's because I misread the original measurements and decided to YOLO it and make it a little longer on one side. It covers the entire gang plate so you can't even tell, let alone the fact there's a cable hanging down with it. The holes in the band are where you can use a screwdriver/drill to put the screws in the box.

I recommend printing this at an angle to reduce the amount of support material needed. I included a photo for reference.

Tags