1 / 2
Neptune 4 Pro extruder mount for BTT SFS V1 — zdjęcie 1
1 / 2

Neptune 4 Pro extruder mount for BTT SFS V1

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Custom mount and instructions to add the Bigtree Tech Smart Filament Sensor V1 to the Neptune 4 Pro.

Ocena
0 / 5
Polubienia
3
Pobrania
7
Wydruki
0
Wyświetlenia
155
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Recently had a couple of failures when printing due to filament getting stuck entering the extruder. When I checked, the filament had a kink that was causing it to get stuck. I don't know if it was already in the filament, or if it kinked while spooling to the extruder, but it was enough to stop the extruder from pulling it in.

I have a BTT Smart Filament Sensor (SFS) V1 from a prior 3D printer and decided to replace the stock runout sensor on the N4Pro. 

I had to modify the cable to fit the 4-pin connector on the BTT SFS. I was hoping to just swap the pins to a new 4-pin plug, but they were too large. I had to snip the ends off and crimp new pins to fit my plugs. I have included a photo of the pin outs to help others with the connections.

Next, modify the printer.cfg file and comment out the old filament_switch_sensor section and add the filament_motion_sensor as shown below.

# [filament_switch_sensor fila]
# pause_on_runout: True
# runout_gcode:
#     SET_FILAMENT_SENSOR SENSOR=fila ENABLE=1
# insert_gcode:
# event_delay: 3.0
# pause_delay: 1.0
# switch_pin: PA12

[filament_motion_sensor fila] detection_length: 7.0 extruder: extruder switch_pin: PA12 pause_on_runout: False runout_gcode: M600 M117 Filament Encoder Runout insert_gcode: M117 Filament Encoder Inserted

Once I Saved and Restarted, I tested the sensor by starting a print, cutting the filament before the sensor. After it paused and I reloaded I then cut the filament after the sensor. Each time, after a few seconds, the N4Pro paused to allow me to insert new filament. Pressing Resume on the display unit was all that was needed.

    

Tagi