1 / 2
Neptune 4 Pro extruder mount for BTT SFS V1 — image 1
1 / 2

Neptune 4 Pro extruder mount for BTT SFS V1

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Custom mount and instructions to add the Bigtree Tech Smart Filament Sensor V1 to the Neptune 4 Pro.

Rating
0 / 5
Likes
3
Downloads
7
Makes
0
Views
155
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Recently had a couple of failures when printing due to filament getting stuck entering the extruder. When I checked, the filament had a kink that was causing it to get stuck. I don't know if it was already in the filament, or if it kinked while spooling to the extruder, but it was enough to stop the extruder from pulling it in.

I have a BTT Smart Filament Sensor (SFS) V1 from a prior 3D printer and decided to replace the stock runout sensor on the N4Pro. 

I had to modify the cable to fit the 4-pin connector on the BTT SFS. I was hoping to just swap the pins to a new 4-pin plug, but they were too large. I had to snip the ends off and crimp new pins to fit my plugs. I have included a photo of the pin outs to help others with the connections.

Next, modify the printer.cfg file and comment out the old filament_switch_sensor section and add the filament_motion_sensor as shown below.

# [filament_switch_sensor fila]
# pause_on_runout: True
# runout_gcode:
#     SET_FILAMENT_SENSOR SENSOR=fila ENABLE=1
# insert_gcode:
# event_delay: 3.0
# pause_delay: 1.0
# switch_pin: PA12

[filament_motion_sensor fila] detection_length: 7.0 extruder: extruder switch_pin: PA12 pause_on_runout: False runout_gcode: M600 M117 Filament Encoder Runout insert_gcode: M117 Filament Encoder Inserted

Once I Saved and Restarted, I tested the sensor by starting a print, cutting the filament before the sensor. After it paused and I reloaded I then cut the filament after the sensor. Each time, after a few seconds, the N4Pro paused to allow me to insert new filament. Pressing Resume on the display unit was all that was needed.

    

Tags