2025 Party Glasses - New Years

Fun glasses to help celebrate the arrival of the new year - 2025.

Printing:

• Shown in Sparta3D.ca Galaxy PLA
• Use brim for the Left and Right glasses arms if required
• Supports not required. 
• Print at 0.2mm layer height 

Assembly:

• Remove glasses arms brims if they were used and clean the edges if required.
• Bend the glasses frame at the nose bridge area just a little bit using hot water or heat gun. 
• Remove the built in support piece from the glasses arms at the hinge area, be cautious here as there's not a lot of material. (see GIF in gallery)
• Test the hole size and use 1.75mm filament as a hinge, the holes might need to be enlarged depending on your printer and settings.
• Slide the glasses arms onto the frame and insert the filament through the arm and frame hinge.
• Trim the end of the filament, and if possible use a little heat to squish the filament and make a "mushroom" on the top and bottom so the filament hinge doesn't fall out
• Happy New Year!