Adafruit Sensor Case with cut-out and LED blocker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adafruit sensor-board case: blocks annoying LED power light and opens the center for sensors like Time-of-Flight.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 145
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Remix of small case for all 0.7 x 1 inch Adafruit boards, but with a “cover” on one end to blunt the effect of the LED power light. The other modification is to remove the center bar to expose any boards that have mid-mounted sensors that need non-obstructed views, like TIme-of-Flight sensors (VL6180X).
Per the original, not designed for a lot of open/close, so it's advised to make sure the LED cover is on the correct side of the box/sensor.
Note: if you print the bottom in a “clear” filament, there's a nice side-glow effect. For convenience, the OG bottom and this new top are available separately.