Adafruit Sensor Case with cut-out and LED blocker
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adafruit sensor-board case: blocks annoying LED power light and opens the center for sensors like Time-of-Flight.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 23
- Makes
- 0
- Views
- 145
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Remix of small case for all 0.7 x 1 inch Adafruit boards, but with a “cover” on one end to blunt the effect of the LED power light. The other modification is to remove the center bar to expose any boards that have mid-mounted sensors that need non-obstructed views, like TIme-of-Flight sensors (VL6180X).
Per the original, not designed for a lot of open/close, so it's advised to make sure the LED cover is on the correct side of the box/sensor.
Note: if you print the bottom in a “clear” filament, there's a nice side-glow effect. For convenience, the OG bottom and this new top are available separately.