"Gecko" mITX SFF Case

The case measures 25x20x9cm for a total volume of 4.5 liters.

It supports coolers up to 70mm in height, and low profile GPUs with a total length of 185mm.

This case is meant to be used with a HDPLEX 250W GaN PSU or picoPSU or any clone of them.

It features a 16mm hole for a “low profile” vandal power switch and an adapter for the PicoPSU barrel port to be mounted on the back panel.

The “low profile” vandal power switch is REQUIRED if you opt for the HDPLEX 250W GaN PSU (otherwise it will not fit).

The NVME Cover Clip is separate from the NVME Cover and should be printed on its side for added strength, then glued into the recess.

Components required:

• 32 4x1.5mm neodymium magnets (main & side panels) ALIEXPRESS
• 19 M3x3mm brass heatset inserts (4.2mm outside diameter) ALIEXPRESS
• 9 countersunk M3x6 screws (motherboard & feet) ALIEXPRESS
• 8 countersunk M3x9 screws (side panels / securing the frame) ALIEXPRESS
• 1 16mm vandal power switch ALIEXPRESS
• 1 HDPLEX 250W GaN PSU / PicoPSU of your required wattage

The example pictures are of my highly customized version with a StreamDeck Mini embedded in the front panel, potentiometers for controlling application volume as well as a front panel audio jack.

You can either screw the main panels with the screws to secure the “skeleton” of the case, leaving the side panels easily removable (magnetically attached), or screw the side panels as well with the same screws for safe transportation.