1 / 1
LDO Nitehawk Umbilical Exhaust Plate for Voron 2.4 - 2 Toolheads — zdjęcie 1

LDO Nitehawk Umbilical Exhaust Plate for Voron 2.4 - 2 Toolheads

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows LDO Nitehawk umbilicals to pass into the print chamber.

Ocena
5 / 5
Polubienia
11
Pobrania
88
Wydruki
0
Wyświetlenia
1324
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is a replacement exhaust plate for the Voron 2.4 intended to allow umbilicals to pass into the print chamber. Print from ABS/ASA. Requires modification to rear enclosure panel, three M3 heat set fittings, and three M3x8 SHCS.

 

Included parts:

exhaust-plate-base.stl

-This is the actual exhaust plate replacement. Install 3x M3 heat set fittings.

 

exhaust-plate-lock.stl

-This is the part that will lock the PG7 blocks in plate. Attaches to the base with 3x M3x8 SHCS.

 

pg7-block.stl

-This part has interrupted threads to allow you to non-destructively fit your umbilical cable in before tightening down the PG7 cable glands. They slip into the exhaust plate base on rails and are retained with the exhaust plate lock.