1 / 4
Parkside mitre saw stop block
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fits on support bar, both sides
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 595
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (26)Powiązane
Original design leaves a lot to desire, so I designed a simple block which you can put on the support rail, slide it along and tighten with a thumbscrews in place. It will widen the range up to about 35cm. Obviously, you can use it on both sides of the saw.
- Extra hardware required is 2x 5mm heatinsert and 2x M5x16 HH screw
- I'd recommend to print from PETG here, so it can withstand some rough handling
- There are some tiny supports
- PrusaSlicer file, it can have issues in clones/forks
